There’s a cereal bowl on the left if that helps.

Depends on how dense the board is. Infill is a choice when printing, so more plastic means more cost. I get my filament from $10 to $20 kg. Depends on sales and colors and such. These prints cost me $2 ish.

Theres a cereal bowl to the left. No bananas in it tho.

Desk knick knacks.

I wouldn’t do that in the slicer, it’s too hard to align them. I don’t know about any alignment tools in slicers. I could do that in Fusion360, however.

Good eye, bub.

Got them for free, other wise I wouldn’t. They’re also only 3 gallons, so a lot easier to handle. Haven’t tried them yet, but a porter is going in this weekend.

Check out some of the references! They were so flimsy.

None. It was store bought juice labeled apple strawberry banana.

Yes. There are several I’ve seen advertised but I’ve never used. Pcbway, despite the name, has 3d printing services. I have no experience with them.

I don’t like curves in 3d prints, generally. They’re all chamfered. The original has some curves.

I did try a brim. It was a huge hassle to remove. I don’t mind brims on larger, simple parts, but on these smaller, intricate ones, it sucks.

I swear I posted it! What the heck.

You are insufferable, why are you even here? Never mind I won’t read your answer.

Pressure switch in the bottom maybe?

Do you actually wanna discuss this or do you just want to rant at people like a jerk? I’ll gladly discuss it calmly but you’re being a total jerk.

Bloop bloop bloop.

Why does that turtle have the remote?

Haha thanks.

Not my model, so I can’t say. I do agree that the point should be a little more rounded.

De label them as you go? Not a bad idea.

Ive tried oxi clean and it works but it destroys my hands and needs rinsing off. I like baking soda. It’s weaker and gets consumed faster but it’s easier on my hands and cheap.

Valid question. As others have said, it’s for change ability. I do write in sharpie on the box for the box capacity and contents. However, I have 3 or 4 of these boxes and I swap around the stuff in them a lot. It’s always bottles but sometimes the box is full, sometimes not. Some bottles are ready, some need de labeling. This way I know at a glance what the status of my inventory is.