• 0 Posts
  • 41 Comments
Joined 1 year ago
cake
Cake day: June 15th, 2023

help-circle








  • Heastes@lemmy.worldtoSelfhosted@lemmy.worldRouters
    link
    fedilink
    English
    arrow-up
    4
    ·
    1 year ago

    I’m using a thinclient (Fujitsu S920), slapped an Intel Pro/1000 NIC in there and installed opnsense. Hardware cost for both used was around €80. Wifi is handled by a TP-Link access point.

    It’s a big boy router/firewall, and it’s been quite a learning experience but very fun.










  • Heastes@lemmy.worldto3DPrinting@lemmy.worldTips for PETG?
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    That’s so strange, I have no problems printing PETG all the time.

    Yeah, I don’t know - I’ve never had any big issues in the past with it either (I mostly print PLA+ though, unless I need something more heat-resistant for my car or outdoor use).

    This particular issue was with an Ender 3 V2 running a BLTouch and an aftermarket textured PEI sheet in an enclosure - so there were no drafts or anything that would explain the bad adhesion either. Just scrubbed it with some water and dish soap. That was literally the only thing I messed with between the spaghetti result run and a great first layer run, so I figured I’d mention it in case it might help OP.



  • Heastes@lemmy.worldto3DPrinting@lemmy.worldTips for PETG?
    link
    fedilink
    English
    arrow-up
    3
    ·
    1 year ago

    I’m exclusively using textured PEI surfaces on my printers, and I can strongly recommend them as well. That’s why it was so surprising to see PETG refusing to stick, even though my first layer with PLA was having no issues at all.

    I mostly print PLA, and I was just done doing maintenance on the frame and doing some calibration, etc. Everything was dialed in - the only thing I didn’t bother with was the bed because I had no issues with PLA.
    Literally, the only change between PETG spaghetti and a great first layer was cleaning the bed.